How to Curl Hair with a Flat Iron: Waves, Curls and the Twist Technique

Three ways to curl your hair with a flat iron, from beachy waves to bouncy curls, plus heat settings, protection and tips to make curls last all day.

A flat iron is one of the most versatile tools you can own. Most people only use it to straighten, but with the right technique it creates everything from loose beach waves to bouncy, defined curls. It’s my go-to tool when I travel for work because it does the job of a straightener and a curling iron at once. Here are the three techniques I use most, and how to make the curls last.

Choosing the right flat iron

  • Plate width: 1 inch (2.5 cm) is the most versatile for curling. Wider plates make looser waves and are harder to turn; narrower ones make tighter curls.
  • Rounded edges: plates with rounded outer edges glide better when turning and don’t leave dents.
  • Adjustable temperature: essential so you can use the lowest effective heat for your hair.
  • Plate material: ceramic heats evenly and is gentle; titanium heats fast and suits thick hair.

Heat settings: protect your hair

Hair type Suggested range
Fine, damaged or color-treated Low: around 250–300°F (120–150°C)
Normal, medium Medium: around 300–375°F (150–190°C)
Thick, coarse, resistant Medium-high: around 375–400°F (190–205°C)

Always start lower and increase only if your hair doesn’t hold the curl. Follow your tool’s instructions, and never use a flat iron on wet or damp hair; you’ll hear sizzling, which is the water boiling inside the hair.

Prep

  1. Start with completely dry hair.
  2. Spray a heat protectant evenly through the lengths and ends.
  3. Add a little texturizing spray or mousse at the roots if your hair doesn’t hold curls well.
  4. Brush out tangles and section the hair: two layers (top and bottom) at least, clipped up.
Artist tip Heat protectant works best when it’s fully dry before you use the iron. Spray it, comb through, and wait a minute. If you hear sizzling, your hair or the product is still wet.

Technique 1: The twist (bouncy curls)

This is the classic flat iron curl.

  1. Take a 1-inch section of hair.
  2. Clamp the iron near the root (not touching the scalp), with the iron horizontal.
  3. Turn the iron a half turn (180 degrees) away from your face, so the hair wraps around the plate.
  4. Slowly glide the iron down the hair while keeping that half turn. The slower you glide, the tighter the curl.
  5. Release at the ends and let the curl fall into your hand. Let it cool before touching.

Alternate the direction on the back for a natural look, but always turn away from your face on the front sections.

Technique 2: The flat wave (beachy waves)

For undone, «S»-shaped waves.

  1. Take a 1- to 2-inch section.
  2. Clamp the iron near the top of the section, and bend it down, then up, moving along the section and alternating the direction every inch or so, like a «zigzag».
  3. Alternatively, twist the section tightly into a rope and glide the iron slowly down the twisted rope. Let it cool, then untwist.
  4. Leave the last inch straight for a modern finish.

The twist-and-press method is perfect for beachy texture; pair it with my DIY sea salt spray.

Technique 3: The wrap (defined curls)

For more defined, ringlet-like curls.

  1. Hold the iron vertically and open it.
  2. Wrap a section of hair around the closed iron (like a curling iron), from root to ends.
  3. Close the iron gently on the wrapped hair and hold for a few seconds.
  4. Slide the iron down and out, letting the curl drop.

This technique works best with rounded plates. Be careful with your fingers; a heat-resistant glove helps.

Finishing

  • Let all curls cool completely before touching. Cooling sets the shape.
  • For soft waves, rake your fingers through the curls gently, or brush them out with a wide-tooth comb.
  • Mist with a flexible hairspray from about 12 inches away.
  • A drop of hair oil or serum on the ends adds shine and reduces frizz.

Making curls last

  • Use texture first: very clean, silky hair doesn’t hold curls; texturizing spray or dry shampoo helps.
  • Pin while cooling: pin each curl in a loop against your head with a clip until it cools, then release. This is how stylists make curls last all day.
  • Smaller sections hold better.
  • Use hairspray before and after: a light mist on each section before curling helps, but let it dry first.

Common mistakes

Problem Cause Fix
Dents or kinks Gliding unevenly or pausing Keep a steady, slow motion
Curls fall flat Hair too clean, sections too big, not cooled Texture, smaller sections, let curls cool
Frizz Damaged hair or heat too high Lower heat, use protectant and a drop of oil
Curls look uneven Different section sizes Use clips and consistent sections
Straight ends Gliding too fast at the end Slow down at the ends, or leave them straight on purpose

Keeping hair healthy with heat styling

Heat styling occasionally is fine for most hair, but daily high heat can lead to dryness and breakage. Use heat protectant every time, use the lowest effective temperature, give your hair heat-free days, and use a hydrating mask weekly. For heat-free alternatives, read heatless curls, and for an event style that starts with flat-iron curls, see my elegant half updo tutorial.

Curling different hair lengths

Bob and short hair

Use a narrow flat iron and the twist technique with a quarter turn instead of a half turn; a full half turn on short hair can look too «done». Start at mid-length rather than the root, leave the ends slightly straight, and scrunch with a little texture spray for a modern, lived-in bob.

Shoulder-length hair

The flat wave and twist techniques both work beautifully. Alternate the direction of each section for natural movement, and keep the front sections turning away from your face.

Long hair

Long hair is heavy, so curls drop faster. Use smaller sections, start the curl a little higher, and pin each curl to cool. A few spritzes of hairspray on each section before curling helps them hold. For very long hair, a slightly higher temperature may be needed, but always within the safe range for your hair type.

Curling layered hair and face-framing pieces

The front pieces are what people see first, so give them extra care. Curl them away from your face, at a slightly lower temperature because hair near the face is often finer. For curtain bangs, clamp near the root, turn the iron slightly back, and glide out in one smooth motion to create a soft bend rather than a full curl. Short layers can be curled with a quarter turn so they blend into the longer curls.

Cleaning and caring for your flat iron

Product buildup on the plates makes the iron drag and heat unevenly, which can cause snagging and uneven curls. Once the iron is unplugged and completely cool, wipe the plates with a soft cloth slightly dampened with water or a little rubbing alcohol. Never use abrasive pads on ceramic plates. Store the iron with its heat-resistant pouch or on a heat-safe surface, and never leave it on unattended.

FAQs

Is a flat iron or a curling iron better for curls?

A curling iron is easier for uniform curls; a flat iron is more versatile and great for waves. If you can only buy one tool, a 1-inch flat iron does both straightening and curling.

Can I curl short hair with a flat iron?

Yes, with a narrow flat iron (1 inch or less), using the twist or flat wave technique for bob-length hair.

Why does my hair not hold curls?

Usually because it’s too clean or too heavy. Use texturizing spray or mousse, smaller sections, and let curls cool before touching.

How do I curl hair with a flat iron without damage?

Use heat protectant, the lowest heat that works, a single slow pass per section, and limit heat styling to a few times a week.

It takes a little practice to get the turning motion right, so try a few sections at the back first. Once your hands learn the movement, you’ll be able to curl your whole head in fifteen minutes.

Bianca Añez
Bianca AñezMakeup & Hair Artist · Licensed Facial Specialist

Miami-based makeup and hair artist and licensed facial specialist with more than 10 years of experience, specializing in bridal and special-occasion beauty. More about Bianca →